How to change and replace the rear wheel bearing on a 2000 528i, without removing the axle. Special thanks to http://TheisMotorsport.com Check them out for all your Genuine BMW parts - if you don''t see it, just ask. They're usually able to beat the prices of the bigger sellers.

Tools used:
1/2" 36mm 12 pt socket for axle nut: https://amzn.to/307Dpa6
1/2" Breaker Bar to loosen axle nut: https://amzn.to/3kHxgLj
Strong Impact and air compressor is optional
1/2" Torque Wrench
3/8" Ratchet, extensions, universal joint or wobble extensions
3/8" E14 socket for bearing assembly: https://amzn.to/3uTQUZw
2-3 jaw puller: 3-jaw puller https://amzn.to/3efaF7Z
Bearing Separator (optional) https://amzn.to/3uPlfYY
Red Locktite: https://amzn.to/2NX0D0l
Antisieze
16mm socket or wrench for caliper bolt
6mm hex socket for rotor screw
Rubber Mallet
Small Chisel
Big Hammer
Dremel or Grinder
Crescent Wrench or a flat piece of thick steel
PB Blaster if you're in the rust belt
Jack & Stands
Something to hang or rest the unbolted caliper

NOTE: When being installed, the (4) E14 bolts are torqued to 22 ft lbs, and then turned an additional 90° (quarter turn).


I don't have Patreon or ask for donations but you can support the channel with some rad gear from my store: http://6thgeargarage.com/merchandise/

Follow Us:
Instagram: 6th_gear
facebook.com/6thGearGarage

Hochgeladen am 04.01.2018   Problem melden   Dieses Video bei YouTube   6th Gear Garage bei Youtube